Recently Updated Pages
Auto Speed - The cruise control for irrigation
Automatic Speed adjustment via remote control on the hose reel To use Auto Speed, you need an ...
Before irrigation - Checklist
Before each irrigation, it is necessary to prepare the sector control to ensure trouble-free oper...
The Master Data - Crops and Soils
Within this section of the Raindancer System, you oversee the management of crops, units, and s...
Create Users and Manage Rights
In the Raindancer portal, select Config on the left-hand side, then User You should now be in th...
Getting started with Raindancer
Congratulations on your decision to work with Raindancer. Thank you for your trust and welcome t...
Setup Notifications
To have employees notified, follow these steps. How to set notifications On the raindancer po...
Create a Run
Irrigation runs permanently stores the path of the irrigation machine in the system. This informa...
Create a Well
The term well refers to all water sources that are used for irrigation. Managing one or more wel...
Choosing The Perfect Angle
How do you actually set the stops on the gun to ensure the most even water distribution possibl...
Manual Sector Control
Basically, you have two operating modes with the sector control: AUTO:ON ⇾ You let Raindance...
Initial start-up of the sector control
After mounting it is important to configure the sector control for the first time. Read the Zero...
Install Sector Control correctly
Mounting a Sector Control on a Irrigation Trolley. What do I have to do? Remove the cannon...
Setup Hüdig Control
The following settings must be made for Hüdig Controls. Activation of the GSM/SMS controlSave ...
Grant or Revoke Third Party Access
When your account is created, a service account is always created which gives the Raindancer-Supo...
Troubleshooting the Beacon
Compatibility check: Beacons are immediately ready for use on the Ethernet module (in comb...
Install the Motor Box Correctly
In this guide, we will explain the steps you need to take to repair your motorbox. Mounting De...
Calibration of Analogue Inputs and Outputs
Ideally, there is a direct, linear connection between the value of an analogue input or output of...
Operation Mode »Mirror Image«
A combination of two or more Raindancer Beacons can optionally be used to reflect another device ...
Typical Wiring Variants
Connecting an analog sensor (AIN field) or analog actuator (AOUT field) in series...
Initial start-up of the M2M router
Optionally, the Raindancer Beacon comes with a preconfigured, ready-to-use M2M Router(M2M – »Mach...