Search Results

Click on the irrigator and go to the buttons More → Settings → Sector Adjustment → Ext. Settings Measurement  Sometimes the point to which the stop is set does not correspond exactly to the point at which the gun changes the direction of the pan. To acc...

Compatibility check: Beacons are immediately ready for use on the Ethernet module (in combination with a router with active DHCP). There is a known incompatibility with certain versions of the Ethernet module (specifically: Rev.4.2, labelled accordin...

Mounting a Sector Control on a Irrigation Trolley.  What do I have to do? Remove the cannon. Remove the cannon stops. Place the seals between the flanges. Align the sector control so that the blue motor box faces the hose reel. Fasten the supplie...

Basically, you have two operating modes with the sector control: AUTO:ON ⇾ You let Raindancer calculate and automatically set the stop angles  AUTO:OFF ⇾ You switch off the automatic system and set the stop angles yourself    To set Auto:On/Off...

How do you actually set the stops on the gun to ensure the most even water distribution possible? We therefore took the time in late summer to take some measurements. The water distribution of an irrigation run naturally depends on the setting of the sto...

Before each irrigation, it is necessary to prepare the sector control to ensure trouble-free operation from the start. A connection to the Raindancer is usually only made every 7 minutes!The correction of the stops is therefore not done immediately. Checklis...

Introduction We leave the installation of the solar module up to you. You should ensure that the solar module is mounted horizontally on your gun carriage construction with a clear "view" of the sky. Shading of the solar panel should also be avoided for the...

To reset the module, you need the reset stick. Simply insert this reset stick into the appropriate connector on your Raindancer module. It is the port to which the pressure sensor is usually connected. Connect the reset stick straight and pull it straight ou...

If the solar module is dirty, you can clean it with a cleaning sponge with the "hard cleaning side" Solar panels must not be cleaned with high-pressure cleaners. Do not use aggressive chemicals to avoid damaging the seals. A kitchen sponge w...

If your irrigator is stored indoors for several days, the solar module will discharge. You should allow approx. 2 days for charging after discharging in good sunlight. We recommend that you put the solar module into hibernation in autumn - it will then only t...

For transport, you should fix the gun (e.g. with a rope) or fold up the stop on the gun.Otherwise, the gun may hit the stops and bend them during transport Alternatively, you can simply decouple the stops of the sector control.

In these guide, we will take you through the necessary steps to replace the base plate including the motors. This is only necessary if your motors are faulty and you have been sent a replacement kit. The removal of the box is identical: Removing the motor b...

This section explains how to remove the gasket between the base plate and the blue box cap.  It is possible that the electronics of the motor box do not correctly detect the revolutions of the motors, which either leads to a blocked stop error message or to t...