Manual Sector Control

Basically, you have two operating modes with the sector control:

AUTO:ON ⇾ You let Raindancer calculate and automatically set the stop angles
AUTO:OFF ⇾ You switch off the automatic system and set the stop angles yourself

To set Auto:On/Off, go to the irrigator, then to the Sector Area.
Here you will find the "AUTO" switch for switching over.

You normally work in automatic mode (AUTO:ON).
The stops are calculated by the raindancer and set automatically.

If you want to set the stop angles manually on the smartphone, switch to AUTO:OFF

You will now be asked whether you want to switch ...

Permanently - i.e. until you later say yourself: now it should "automatically set the sector" again
Until the end of the operation - i.e. only for this gear
For a period of time (e.g. 120 min) - i.e. for a limited time, after which it will switch back to automatic sector control.
When could this be done?
e.g. if a stop is to be set to 50° for 2 hours when the wind is blowing in the evening.

The connection to the raindancer is usually only established every 7 minutes!
The correction of the stops is therefore not immediate.