Manual Sector Control

Basically, you have two operating modes with the sector control: 

 

 

 AUTO:ON ⇾ You let Raindancer calculate and automatically set the stop angles  

 

 

 AUTO:OFF ⇾ You switch off the automatic system and set the stop angles yourself  

   

 

 

 To set Auto:On/Off , go to the irrigator , then to the Sector Area . Here you will find the " AUTO " switch for switching over. 

 Y ou normally work in automatic mode ( AUTO:ON ). The stops are calculated by the raindancer and set automatically. 

 Manual Adjustments 

 If you want to set the stop angles manually on the smartphone, switch to AUTO:OFF 

 You will now be asked whether you want to switch ... 

 

 Permanently - i.e. until you later say yourself: now it should "automatically set the sector" again 

 Until the end of the operation - i.e. only for this gear 

 For a period of time (e.g. 120 min) - i.e. for a limited time, after which it will switch back to automatic sector control. When could this be done? e.g. if a stop is to be set to 50° for 2 hours when the wind is blowing in the evening. 

 

 

 

 

 The connection to the raindancer is usually only established  every 7 minutes ! The correction of the stops is therefore not immediate.